Saturday, January 23, 2016

making the edges for the escape hatch panel

I started with bending a foam strip around the old cutout from the front hatch with two head guns. This old cutout was almost the same diameter what I did need. I put the flat panel with screws on a board with some packing tape on it. I than glued the edge with some PU construction glue. I put some wood pieces on the outside to press the edge to the flat panel. In the afternoon I laminated the inside of this panel. I did also the inspection port to the holding tank top panel. This inspection port has to be lowered to keep it below the surface of the top panel.


No comments:

Post a Comment